Crane Rigging Safety Course in Rawalpindi

September 30, 2022
According to Requirement


051-8736681, 0311-5193625, 0092-335-4176949, Office # 27, Second Floor, Maryam Shadi Hall Plaza (Airies Plaza), Shamsabad, Murree Road, Rawalpindi, Pakistan 46000   View map


Safety Courses

Crane Rigging Safety Course in Rawalpindi

This crane rigging safety training course teaches employees the safe way to handle crane rigging and all the hazards associated with using cranes while at work. Cranes are used at many workplaces, across all major industries, to lift and move materials. Crane operators are generally trained and often certified in safe crane operations and inspection. However, many accidents involving cranes are caused by failures of crane rigging and rigging hardware.This course is designed for participants to gain the necessary skills to plan, prepare & complete basic rigging. On completion of this course, participants will be able to undertake the movement of plant and equipment, steel erection, use hoists (including mast climbing hoists), undertake the placement of pre-cast concrete, use safety nets and static lines, install perimeter safety screens, shutters and cantilevered crane-loading platforms.

Key Points:
There is certainly a lot to learn about rigging a crane; that’s why crane rigging is often referred to as an art, and it takes years of practice to be a true expert.
Because lifts often present new situations that require thought and sound decisions, you should never be bored at work!
It is important that you continue to learn and find out all you can about the practice of rigging cranes.
As you learn, keep in mind that you need to be cautious at all times, and think safety. It is up to you to never allow a lift that you even suspect could be unsafe.
Finally, while unusual lifts may require special thought, even routine lifts can be deadly if a sling fails or if the rigger forgets to fasten the crane hook. That’s why it is essential that you follow all procedures every time, and think safety.

Course Outline:
Crane and hoisting hand signals
Load weight estimation
Location of the load centre of gravity (COG)
Rigging hardware and appropriate uses
Rigging hardware inspection and rejection criteria (regulations varied by jurisdiction)
Use of rigging tables to select appropriate hardware for hoisting
Sling angle capacity calculation
Care and storage of rigging hardware
Common hazards and safety around cranes and overhead hoists
Lift planning and advanced topics awareness
Wire Rope
Wire Rope Classification
Wedge Sockets
Wire Rope Clips
Sling Inspection
Chain Slings
Synthetic Slings
Sling Angles
Sling Care
Other Hitches
D/d Ratio
Hoisting Personnel
Power Lines
Crane Safety
Signal Person
Hand Signal Chart

For Registration: 0092-311-5193625 / 0092-335-4176949

Crane Rigging Safety Course in Rawalpindi

Leave a Reply

Your email address will not be published.